/* SPDX-License-Identifier: GPL-2.0-only */
/*
* Copyright ( c ) 2022 - 2023 Qualcomm Innovation Center , Inc . All rights reserved .
* Copyright ( c ) 2015 - 2018 , The Linux Foundation . All rights reserved .
*/
#ifndef _DPU_HW_INTF_H
#define _DPU_HW_INTF_H
#include "dpu_hw_catalog.h"
#include "dpu_hw_mdss.h"
#include "dpu_hw_util.h"
struct dpu_hw_intf;
/* intf timing settings */
struct dpu_hw_intf_timing_params {
u32 width; /* active width */
u32 height; /* active height */
u32 xres; /* Display panel width */
u32 yres; /* Display panel height */
u32 h_back_porch;
u32 h_front_porch;
u32 v_back_porch;
u32 v_front_porch;
u32 hsync_pulse_width;
u32 vsync_pulse_width;
u32 hsync_polarity;
u32 vsync_polarity;
u32 border_clr;
u32 underflow_clr;
u32 hsync_skew;
bool wide_bus_en;
bool compression_en;
};
struct dpu_hw_intf_prog_fetch {
u8 enable;
/* vsync counter for the front porch pixel line */
u32 fetch_start;
};
struct dpu_hw_intf_status {
u8 is_en; /* interface timing engine is enabled or not */
u8 is_prog_fetch_en; /* interface prog fetch counter is enabled or not */
u32 frame_count; /* frame count since timing engine enabled */
u32 line_count; /* current line count including blanking */
};
struct dpu_hw_intf_cmd_mode_cfg {
u8 data_compress; /* enable data compress between dpu and dsi */
u8 wide_bus_en; /* enable databus widen mode */
};
/**
* struct dpu_hw_intf_ops : Interface to the interface Hw driver functions
* Assumption is these functions will be called after clocks are enabled
* @ setup_timing_gen : programs the timing engine
* @ setup_prog_fetch : enables / disables the programmable fetch logic
* @ enable_timing : enable / disable timing engine
* @ get_status : returns if timing engine is enabled or not
* @ get_line_count : reads current vertical line counter
* @ bind_pingpong_blk : enable / disable the connection with pingpong which will
* feed pixels to this interface
* @ setup_misr : enable / disable MISR
* @ collect_misr : read MISR signature
* @ enable_tearcheck : Enables vsync generation and sets up init value of read
* pointer and programs the tear check configuration
* @ disable_tearcheck : Disables tearcheck block
* @ connect_external_te : Read , modify , write to either set or clear listening to external TE
* Return : 1 if TE was originally connected , 0 if not , or - ERROR
* @ get_vsync_info : Provides the programmed and current line_count
* @ setup_autorefresh : Configure and enable the autorefresh config
* @ get_autorefresh : Retrieve autorefresh config from hardware
* Return : 0 on success , - ETIMEDOUT on timeout
* @ vsync_sel : Select vsync signal for tear - effect configuration
* @ program_intf_cmd_cfg : Program the DPU to interface datapath for command mode
*/
struct dpu_hw_intf_ops {
void (*setup_timing_gen)(struct dpu_hw_intf *intf,
const struct dpu_hw_intf_timing_params *p,
const struct msm_format *fmt);
void (*setup_prg_fetch)(struct dpu_hw_intf *intf,
const struct dpu_hw_intf_prog_fetch *fetch);
void (*enable_timing)(struct dpu_hw_intf *intf,
u8 enable);
void (*get_status)(struct dpu_hw_intf *intf,
struct dpu_hw_intf_status *status);
u32 (*get_line_count)(struct dpu_hw_intf *intf);
void (*bind_pingpong_blk)(struct dpu_hw_intf *intf,
const enum dpu_pingpong pp);
void (*setup_misr)(struct dpu_hw_intf *intf);
int (*collect_misr)(struct dpu_hw_intf *intf, u32 *misr_value);
// Tearcheck on INTF since DPU 5.0.0
int (*enable_tearcheck)(struct dpu_hw_intf *intf, struct dpu_hw_tear_check *cfg);
int (*disable_tearcheck)(struct dpu_hw_intf *intf);
int (*connect_external_te)(struct dpu_hw_intf *intf, bool enable_external_te);
void (*vsync_sel)(struct dpu_hw_intf *intf, enum dpu_vsync_source vsync_source);
/**
* Disable autorefresh if enabled
*/
void (*disable_autorefresh)(struct dpu_hw_intf *intf, uint32_t encoder_id, u16 vdisplay);
void (*program_intf_cmd_cfg)(struct dpu_hw_intf *intf,
struct dpu_hw_intf_cmd_mode_cfg *cmd_mode_cfg);
};
struct dpu_hw_intf {
struct dpu_hw_blk_reg_map hw;
/* intf */
enum dpu_intf idx;
const struct dpu_intf_cfg *cap;
const struct dpu_mdss_version *mdss_ver;
/* ops */
struct dpu_hw_intf_ops ops;
};
struct dpu_hw_intf *dpu_hw_intf_init(struct drm_device *dev,
const struct dpu_intf_cfg *cfg,
void __iomem *addr,
const struct dpu_mdss_version *mdss_rev);
#endif /*_DPU_HW_INTF_H */
Messung V0.5 in Prozent C=86 H=100 G=93
¤ Dauer der Verarbeitung: 0.11 Sekunden
(vorverarbeitet am 2026-10-05)
¤
*© Formatika GbR, Deutschland