RAID Engine nodes are defined to describe on-chip RAID accelerators. Each RAID
Engine should have a separate node.
Supported chips:
P5020, P5040
Required properties:
- compatible: Should contain "fsl,raideng-v1.0" as the value
This identifies RAID Engine block. 1 in 1.0 represents
major number whereas 0 represents minor number. The
version matches the hardware IP version.
- reg: offset and length of the register set for the device
- ranges: standard ranges property specifying the translation
between child address space and parent address space
There must be a sub-node for each job queue present in RAID Engine
This node must be a sub-node of the main RAID Engine node
- compatible: Should contain "fsl,raideng-v1.0-job-queue" as the value
This identifies the job queue interface
- reg: offset and length of the register set for job queue
- ranges: standard ranges property specifying the translation
between child address space and parent address space
There must be a sub-node for each job ring present in RAID Engine
This node must be a sub-node of job queue node
- compatible: Must contain "fsl,raideng-v1.0-job-ring" as the value
This identifies job ring. Should contain either
"fsl,raideng-v1.0-hp-ring" or "fsl,raideng-v1.0-lp-ring"
depending upon whether ring has high or low priority
- reg: offset and length of the register set for job ring
- interrupts: interrupt mapping for job ring IRQ
Optional property:
- fsl,liodn: Specifies the LIODN to be used for Job Ring. This
property is normally set by firmware. Value
is of 12-bits which is the LIODN number for this JR.
This property is used by the IOMMU (PAMU) to distinguish
transactions from this JR and than be able to do address
translation & protection accordingly.
Die Informationen auf dieser Webseite wurden
nach bestem Wissen sorgfältig zusammengestellt. Es wird jedoch weder Vollständigkeit, noch Richtigkeit,
noch Qualität der bereit gestellten Informationen zugesichert.
Bemerkung:
Die farbliche Syntaxdarstellung und die Messung sind noch experimentell.