/* 1.The device has its own operation to switch source of clock */ if (clk_spec) {
err = clk_spec->get(bebob, &id); if (err < 0) {
dev_err(&bebob->unit->device, "fail to get clock source: %d\n", err); goto end;
}
if (id >= clk_spec->num) {
dev_err(&bebob->unit->device, "clock source %d out of range 0..%d\n",
id, clk_spec->num - 1);
err = -EIO; goto end;
}
if (s == &bebob->tx_stream)
dir = AVC_BRIDGECO_PLUG_DIR_OUT; else
dir = AVC_BRIDGECO_PLUG_DIR_IN;
avc_bridgeco_fill_unit_addr(addr, dir, AVC_BRIDGECO_PLUG_UNIT_ISOC, 0);
err = avc_bridgeco_get_plug_ch_pos(bebob->unit, addr, buf, 256); if (err < 0) {
dev_err(&bebob->unit->device, "fail to get channel position for isoc %s plug 0: %d\n",
(dir == AVC_BRIDGECO_PLUG_DIR_IN) ? "in" : "out",
err); goto end;
}
pos = 0;
/* positions in I/O buffer */
pcm = 0;
midi = 0;
/* the number of sections in AMDTP packet */
sections = buf[pos++];
for (sec = 0; sec < sections; sec++) { /* type of this section */
avc_bridgeco_fill_unit_addr(addr, dir,
AVC_BRIDGECO_PLUG_UNIT_ISOC, 0);
err = avc_bridgeco_get_plug_section_type(bebob->unit, addr,
sec, &type); if (err < 0) {
dev_err(&bebob->unit->device, "fail to get section type for isoc %s plug 0: %d\n",
(dir == AVC_BRIDGECO_PLUG_DIR_IN) ? "in" : "out",
err); goto end;
} /* NoType */ if (type == 0xff) {
err = -ENOSYS; goto end;
}
/* the number of channels in this section */
channels = buf[pos++];
for (ch = 0; ch < channels; ch++) { /* position of this channel in AMDTP packet */
stm_pos = buf[pos++] - 1; /* location of this channel in this section */
sec_loc = buf[pos++] - 1;
// MEMO: Some devices start packet transmission long enough after establishment of // CMP connection. In the early stage of packet streaming, any device transfers // NODATA packets. After several hundred cycles, it begins to multiplex event into // the packet with adequate value of syt field in CIP header. Some devices are // strictly to generate any discontinuity in the sequence of tx packet when they // receives inadequate sequence of value in syt field of CIP header. In the case, // the request to break CMP connection is often corrupted, then any transaction // results in unrecoverable error, sometimes generate bus-reset.
err = amdtp_domain_start(&bebob->domain, tx_init_skip_cycles, true, false); if (err < 0) goto error;
// NOTE: // The firmware customized by M-Audio uses these commands to // start transmitting stream. This is not usual way. if (bebob->maudio_special_quirk) {
err = bebob->spec->rate->set(bebob, curr_rate); if (err < 0) {
dev_err(&bebob->unit->device, "fail to ensure sampling rate: %d\n",
err); goto error;
}
}
// Some devices postpone start of transmission mostly for 1 sec after receives // packets firstly. if (!amdtp_domain_wait_ready(&bebob->domain, READY_TIMEOUT_MS)) {
err = -ETIMEDOUT; goto error;
}
}
/* check sampling rate */ for (i = 0; i < ARRAY_SIZE(bridgeco_freq_table); i++) { if (buf[2] == bridgeco_freq_table[i]) break;
} if (i == ARRAY_SIZE(bridgeco_freq_table)) return -ENOSYS;
/* Avoid double count by different entries for the same rate. */
memset(&formation[i], 0, sizeof(struct snd_bebob_stream_formation));
for (e = 0; e < buf[4]; e++) {
channels = buf[5 + e * 2];
format = buf[6 + e * 2];
switch (format) { /* IEC 60958 Conformant, currently handled as MBLA */ case0x00: /* Multi bit linear audio */ case0x06: /* Raw */
formation[i].pcm += channels; break; /* MIDI Conformant */ case0x0d:
formation[i].midi += channels; break; /* IEC 61937-3 to 7 */ case0x01: case0x02: case0x03: case0x04: case0x05: /* Multi bit linear audio */ case0x07: /* DVD-Audio */ case0x0c: /* High Precision */ /* One Bit Audio */ case0x08: /* (Plain) Raw */ case0x09: /* (Plain) SACD */ case0x0a: /* (Encoded) Raw */ case0x0b: /* (Encoded) SACD */ /* Synchronization Stream (Stereo Raw audio) */ case0x40: /* Don't care */ case0xff: default: return -ENOSYS; /* not supported */
}
}
if (formation[i].pcm > AM824_MAX_CHANNELS_FOR_PCM ||
formation[i].midi > AM824_MAX_CHANNELS_FOR_MIDI) return -ENOSYS;
/// Detect the number of available MIDI ports when packet has MIDI conformant data channel. for (i = 0; i < SND_BEBOB_STRM_FMT_ENTRIES; ++i) { if (formats[i].midi > 0) break;
} if (i >= SND_BEBOB_STRM_FMT_ENTRIES) return0;
for (i = 0; i < plug_count; ++i) { enum avc_bridgeco_plug_type plug_type; unsignedint ch_count;
err = avc_bridgeco_get_plug_type(bebob->unit, addr, &plug_type); if (err < 0) {
dev_err(&bebob->unit->device, "fail to get type for external %d plug %d: %d\n",
plug_dir, i, err); break;
} elseif (plug_type != AVC_BRIDGECO_PLUG_TYPE_MIDI) { continue;
}
err = avc_bridgeco_get_plug_ch_count(bebob->unit, addr, &ch_count); if (err < 0) break; // Yamaha GO44, GO46, Terratec Phase 24, Phase x24 reports 0 for the number of // channels in external output plug 3 (MIDI type) even if it has a pair of physical // MIDI jacks. As a workaround, assume it as one. if (ch_count == 0)
ch_count = 1;
*midi_ports += ch_count;
}
/* Get the number of Music Sub Unit for both direction. */
err = avc_general_get_plug_info(bebob->unit, 0x0c, 0x00, 0x00, plugs); if (err < 0) {
dev_err(&bebob->unit->device, "fail to get info for MSU in/out plugs: %d\n",
err); goto end;
}
/* seek destination plugs for 'MSU sync input' */
bebob->sync_input_plug = -1; for (i = 0; i < plugs[0]; i++) {
avc_bridgeco_fill_msu_addr(addr, AVC_BRIDGECO_PLUG_DIR_IN, i);
err = avc_bridgeco_get_plug_type(bebob->unit, addr, &type); if (err < 0) {
dev_err(&bebob->unit->device, "fail to get type for MSU in plug %d: %d\n",
i, err); goto end;
}
int snd_bebob_stream_discover(struct snd_bebob *bebob)
{ conststruct snd_bebob_clock_spec *clk_spec = bebob->spec->clock;
u8 plugs[AVC_PLUG_INFO_BUF_BYTES], addr[AVC_BRIDGECO_ADDR_BYTES]; int err;
/* the number of plugs for isoc in/out, ext in/out */
err = avc_general_get_plug_info(bebob->unit, 0x1f, 0x07, 0x00, plugs); if (err < 0) {
dev_err(&bebob->unit->device, "fail to get info for isoc/external in/out plugs: %d\n",
err); goto end;
}
int snd_bebob_stream_lock_try(struct snd_bebob *bebob)
{ int err;
spin_lock_irq(&bebob->lock);
/* user land lock this */ if (bebob->dev_lock_count < 0) {
err = -EBUSY; goto end;
}
/* this is the first time */ if (bebob->dev_lock_count++ == 0)
snd_bebob_stream_lock_changed(bebob);
err = 0;
end:
spin_unlock_irq(&bebob->lock); return err;
}
Die Informationen auf dieser Webseite wurden
nach bestem Wissen sorgfältig zusammengestellt. Es wird jedoch weder Vollständigkeit, noch Richtigkeit,
noch Qualität der bereit gestellten Informationen zugesichert.
Bemerkung:
Die farbliche Syntaxdarstellung und die Messung sind noch experimentell.