// SPDX-License-Identifier: BSD-3-Clause
/*
* Copyright (c) 2017-2019, The Linux Foundation. All rights reserved.
* Copyright (c) 2021-2023, Linaro Limited
*/
#include <dt-bindings/input/input.h>
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/spmi/spmi.h>
#include <dt-bindings/iio/qcom,spmi-vadc.h>
/ {
thermal-zones {
pmc8180-thermal {
polling-delay-passive = <100>;
thermal-sensors = <&pmc8180_temp>;
trips {
trip0 {
temperature = <95000>;
hysteresis = <0>;
type = "passive";
};
trip1 {
temperature = <115000>;
hysteresis = <0>;
type = "hot";
};
trip2 {
temperature = <145000>;
hysteresis = <0>;
type = "critical";
};
};
};
pmc8180c-thermal {
polling-delay-passive = <100>;
thermal-sensors = <&pmc8180c_temp>;
trips {
trip0 {
temperature = <95000>;
hysteresis = <0>;
type = "passive";
};
trip1 {
temperature = <115000>;
hysteresis = <0>;
type = "hot";
};
trip2 {
temperature = <145000>;
hysteresis = <0>;
type = "critical";
};
};
};
};
};
&spmi_bus {
pmc8180_0: pmic@0 {
compatible = "qcom,pm8150", "qcom,spmi-pmic";
reg = <0x0 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
pon: pon@800 {
compatible = "qcom,pm8916-pon";
reg = <0x0800>;
pmc8180_pwrkey: pwrkey {
compatible = "qcom,pm8941-pwrkey";
interrupts = <0x0 0x8 0x0 IRQ_TYPE_EDGE_BOTH>;
debounce = <15625>;
bias-pull-up;
linux,code = <KEY_POWER>;
status = "disabled";
};
};
pmc8180_temp: temp-alarm@2400 {
compatible = "qcom,spmi-temp-alarm";
reg = <0x2400>;
interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_BOTH>;
io-channels = <&pmc8180_adc ADC5_DIE_TEMP>;
io-channel-names = "thermal";
#thermal-sensor-cells = <0>;
};
pmc8180_adc: adc@3100 {
compatible = "qcom,spmi-adc5";
reg = <0x3100>;
#address-cells = <1>;
#size-cells = <0>;
#io-channel-cells = <1>;
interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
channel@0 {
reg = <ADC5_REF_GND>;
qcom,pre-scaling = <1 1>;
label = "ref_gnd";
};
channel@1 {
reg = <ADC5_1P25VREF>;
qcom,pre-scaling = <1 1>;
label = "vref_1p25";
};
channel@6 {
reg = <ADC5_DIE_TEMP>;
qcom,pre-scaling = <1 1>;
label = "die_temp";
};
};
pmc8180_adc_tm: adc-tm@3500 {
compatible = "qcom,spmi-adc-tm5";
reg = <0x3500>;
interrupts = <0x0 0x35 0x0 IRQ_TYPE_EDGE_RISING>;
#thermal-sensor-cells = <1>;
#address-cells = <1>;
#size-cells = <0>;
status = "disabled";
};
rtc@6000 {
compatible = "qcom,pm8941-rtc";
reg = <0x6000>;
reg-names = "rtc", "alarm";
interrupts = <0x0 0x61 0x1 IRQ_TYPE_NONE>;
};
pmc8180_1_gpios: gpio@c000 {
compatible = "qcom,pmc8180-gpio", "qcom,spmi-gpio";
reg = <0xc000>;
gpio-controller;
gpio-ranges = <&pmc8180_1_gpios 0 0 10>;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
};
};
pmic@1 {
compatible = "qcom,pmc8180", "qcom,spmi-pmic";
reg = <0x1 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
};
pmic@2 {
compatible = "qcom,smb2351", "qcom,spmi-pmic";
reg = <0x2 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
adc@3100 {
compatible = "qcom,spmi-adc-rev2";
reg = <0x3100>;
#address-cells = <1>;
#size-cells = <0>;
#io-channel-cells = <1>;
interrupts = <0x2 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
channel@0 {
reg = <ADC5_REF_GND>;
qcom,pre-scaling = <1 1>;
label = "ref_gnd";
};
channel@1 {
reg = <ADC5_1P25VREF>;
qcom,pre-scaling = <1 1>;
label = "vref_1p25";
};
channel@85 {
reg = <0x85>;
qcom,pre-scaling = <1 1>;
label = "vcoin2";
};
};
};
pmic@6 {
compatible = "qcom,pm8150c", "qcom,spmi-pmic";
reg = <0x6 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
};
pmc8180_2: pmic@8 {
compatible = "qcom,pm8150", "qcom,spmi-pmic";
reg = <0x8 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
pmc8180_2_gpios: gpio@c000 {
compatible = "qcom,pmc8180-gpio", "qcom,spmi-gpio";
reg = <0xc000>;
gpio-controller;
gpio-ranges = <&pmc8180_2_gpios 0 0 10>;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
};
};
pmic@a {
compatible = "qcom,smb2351", "qcom,spmi-pmic";
reg = <0xa SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
adc@3100 {
compatible = "qcom,spmi-adc-rev2";
reg = <0x3100>;
#address-cells = <1>;
#size-cells = <0>;
#io-channel-cells = <1>;
interrupts = <0xa 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
channel@0 {
reg = <ADC5_REF_GND>;
qcom,pre-scaling = <1 1>;
label = "ref_gnd";
};
channel@1 {
reg = <ADC5_1P25VREF>;
qcom,pre-scaling = <1 1>;
label = "vref_1p25";
};
channel@85 {
reg = <0x85>;
qcom,pre-scaling = <1 1>;
label = "vcoin";
};
};
};
pmic@4 {
compatible = "qcom,pm8150c", "qcom,spmi-pmic";
reg = <0x4 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
pon@800 {
compatible = "qcom,pm8916-pon";
reg = <0x0800>;
status = "disabled";
};
pmc8180c_temp: temp-alarm@2400 {
compatible = "qcom,spmi-temp-alarm";
reg = <0x2400>;
interrupts = <0x4 0x24 0x0 IRQ_TYPE_EDGE_BOTH>;
io-channels = <&pmc8180c_adc ADC5_DIE_TEMP>;
io-channel-names = "thermal";
#thermal-sensor-cells = <0>;
};
pmc8180c_adc: adc@3100 {
compatible = "qcom,spmi-adc5";
reg = <0x3100>;
#address-cells = <1>;
#size-cells = <0>;
#io-channel-cells = <1>;
interrupts = <0x4 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
channel@0 {
reg = <ADC5_REF_GND>;
qcom,pre-scaling = <1 1>;
label = "ref_gnd";
};
channel@1 {
reg = <ADC5_1P25VREF>;
qcom,pre-scaling = <1 1>;
label = "vref_1p25";
};
channel@6 {
reg = <ADC5_DIE_TEMP>;
qcom,pre-scaling = <1 1>;
label = "die_temp";
};
};
pmc8180c_adc_tm: adc-tm@3500 {
compatible = "qcom,spmi-adc-tm5";
reg = <0x3500>;
interrupts = <0x4 0x35 0x0 IRQ_TYPE_EDGE_RISING>;
#thermal-sensor-cells = <1>;
#address-cells = <1>;
#size-cells = <0>;
status = "disabled";
};
pmc8180c_gpios: gpio@c000 {
compatible = "qcom,pmc8180c-gpio", "qcom,spmi-gpio";
reg = <0xc000>;
gpio-controller;
gpio-ranges = <&pmc8180c_gpios 0 0 12>;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
};
};
pmic@5 {
compatible = "qcom,pmc8180c", "qcom,spmi-pmic";
reg = <0x5 SPMI_USID>;
pmc8180c_lpg: pwm {
compatible = "qcom,pmc8180c-lpg";
#address-cells = <1>;
#size-cells = <0>;
#pwm-cells = <2>;
status = "disabled";
};
};
};
